Block D, Electrical and Electronic Systems: 22 of the 135 questions. RSOS tasks D-15 (batteries), D-16 (charging), D-17 (spark ignition), D-18 (starting), D-19 (electrical components and accessories) and D-20 (vehicle management systems and data networks).
These are original practice notes, not documents of the Red Seal program. Inspection values come from the National Safety Code standards in force on January 1, 2027, and jurisdictions may vary. Adjustment, torque and clearance values always come from the vehicle manufacturer's documentation. The rest describes standard methods of the trade.
| Symptom | Likely cause | Check |
|---|---|---|
| High starter draw, good batteries and cable drops | Starter internal fault | Bushings, windings |
| Fuse blows with lamps unplugged | Short to ground in the harness | Chafed insulation at the frame |
| Faults with truck movement, clear on key cycle | Chafed harness or loose connector | Wiggle the harness while watching data |
1. Four identical 12 V, 100 Ah batteries are wired as two series pairs, and the two pairs are then connected in parallel. What are the bank voltage and capacity?
Each series pair adds voltage to 24 V and keeps 100 Ah. Connecting the two pairs in parallel keeps 24 V and adds capacity to 200 Ah. 12 V and 400 Ah would be an all-parallel bank, 24 V and 100 Ah forgets the second pair, and 48 V and 100 Ah is an all-series bank. See RSOS sub-task D-15.01.
2. Which battery type holds all of its electrolyte in porous separators packed tightly between the plates, so it is sealed and cannot be topped up with water?
An absorbed glass mat (AGM) battery holds its electrolyte soaked into fine glass-fibre separators pressed between the plates, and it is sealed. A vented flooded-cell battery has removable caps and is topped up with water. A gel cell holds its electrolyte thickened into a gel with silica rather than soaked into separators, and a lithium iron phosphate battery has no lead-acid electrolyte at all. See RSOS sub-task D-15.01, which lists AGM and gel cell batteries.
3. A customer wants a replacement truck battery that can keep the lights and electronics running longer if the alternator fails on the road. Which rating is compared first?
Reserve capacity states how many minutes a fully charged battery can carry the essential loads when the charging system is not working. CCA and CA describe how much current the battery delivers to crank the engine, which does not tell how long it can run accessories. Open-circuit voltage shows the state of charge, not capacity. See RSOS sub-task D-15.03.
4. A technician jump-starts a truck from a booster pack, and both positive clamps are already connected. Where does the last negative clamp go to limit the risk of igniting battery gas?
A charging or discharged lead-acid battery gives off hydrogen, and the last connection can spark, so the last clamp goes on bare engine metal away from the batteries (RSOS sub-task D-15.01 lists explosive gases and sparks). The negative post of the discharged battery would spark right at the gas. The solenoid terminal is the live positive side, and a painted bracket by the vents gives a poor ground next to the gas.
5. A vented battery is fully charged and given an equalizing charge. A hydrometer reads 1.265 in five cells and 1.190 in one cell, and the service information says to replace a battery when cells differ by more than 0.050. What is done next?
The cells differ by 0.075 after the equalizing charge, which is more than the 0.050 limit, so one cell is weak and the battery is replaced. Another equalizing charge only overheats a battery that has already been equalized. Adding acid does not restore a worn cell, and an average reading hides the failed cell. See RSOS sub-task D-15.02.